Service area · Wilson County
Mount Juliet yards built since 2010, and the ground under them
Forty percent of Mount Juliet’s homes went up in 2010 or later, which means a lot of sod rolled out over ground that construction packed hard.
TL;DR
Mount Juliet has 16,952 homes, and 40 percent of them were built in 2010 or later, so most yard trouble here starts with builder-grade sod over compacted subsoil. Under that, Byler soil carries a fragipan that holds water near the surface, Talbott clay drains slowly, and flaggy Inman ground sits on a median slope of 19 percent. The city exempts retaining walls up to 4 feet, measured from the bottom of the footing, from a permit in most cases, and taller ones are not exempt.
Why is the lawn on my newer Mount Juliet house so thin?
Because it was likely laid on construction subsoil. With 40 percent of Mount Juliet’s homes built since 2010, a large share of yards here got the standard builder treatment: topsoil stripped, ground compacted by months of trucks, and sod unrolled across whatever was left. The grass roots stay shallow, and the first hot, dry stretch shows it.
A lasting fix goes under the turf. The compacted layer is broken up, organic matter goes in, low spots and any grade that leans toward the house are corrected, and new sod or seed goes down on ground that roots can enter. That is grading and site prep followed by lawn and yard care, which keeps it going with aeration, overseeding and fertilization.
Why does water pond in my Mount Juliet yard after rain?
In many yards it is the fragipan. Byler, about 13 percent of the ground sampled around Mount Juliet, is a moderately well drained soil with a fragipan, a dense, brittle layer in the subsoil that water passes through very slowly. Rain soaks the top layer, hits the pan and spreads sideways or stays put, so the lawn is squishy long after the sky has cleared. Byler lies on nearly level stream terraces, at a median slope of 3 percent here, which gives water little reason to move.
Surface drainage does more than deep drainage on water perched like that: shallow swales, a French drain placed to intercept it, and downspouts piped well away. Those are all part of drainage solutions.
Do I need a permit for a retaining wall in Mount Juliet?
Not for most walls 4 feet tall or less. The City of Mount Juliet Building & Codes Department lists retaining walls not over 4 feet in height as exempt from a permit, measured from the bottom of the footing to the top of the wall, unless the wall supports a surcharge or impounds flammable liquids. The page cites the 2018 codes.
The measurement matters: a wall that shows 3½ feet above the lawn may be over 4 feet once the buried footing is counted. A surcharge is extra load above the wall, such as a driveway, a parked car or a slope that keeps rising behind it. On sloped Inman ground, at a median 19 percent, a rising slope above the wall is common. Walls are built under hardscape construction.
04Answers
Mount Juliet questions
How tall can a retaining wall be in Mount Juliet without a permit?
Up to 4 feet, measured from the bottom of the footing to the top of the wall, according to the City of Mount Juliet Building and Codes Department, as long as it does not support a surcharge or impound flammable liquids. Anything taller, or carrying a load like a driveway above it, falls outside that exemption.
What is a fragipan, and is there one under my Mount Juliet yard?
It is a hard, compact layer below the surface that water barely gets through. Byler, one of the common soils around Mount Juliet’s center at about 13 percent of the ground, has one. If your yard stays wet on flat ground long after rain while a sloped neighbor’s dries out, a fragipan is a likely reason.
Can I get the sod replaced on a Mount Juliet lot without redoing the whole yard?
Yes. Sodding is something Wilhelm does on its own, not only as part of a full install. On a Mount Juliet lot with builder-grade turf, replacing the sod is worth doing only after the packed ground under it is loosened and amended; otherwise the new grass struggles the same way the old grass did.
What is the ground like on the hills around Mount Juliet?
Rocky in places. Inman soil, about 11 percent of the ground sampled near the city’s center, is a flaggy clay formed from phosphatic limestone and shale on rolling to steep uplands, with a median slope of 19 percent. Expect flat stone in the excavation, and plan for walls, steps and drainage rather than one long sloped lawn.