Service area · Davidson County
Bellevue lots that run from drainageway to ridge
Bellevue’s ground splits between level soils along its drainageways and gravelly hillsides that climb at a 35 percent median slope.
TL;DR
Bellevue is a Metro Nashville community about 12 miles from Wilhelm’s Brentwood base, and in the 37221 ZIP area the median home was built in 1991. Around its center, nearly half the mapped ground is level Armour and Arrington soil on terraces, flood plains and drainageways, while 18 percent is Bodine, a gravelly soil on slopes with a median grade of 35 percent. Hillside lots need walls and steps; low ones need a plan for moving water. Cutting trees there requires a Metro removal permit.
How do you landscape a steep, wooded lot in Bellevue?
In steps, with the trees and the slope planned together. Bodine, 18 percent of the ground mapped around Bellevue, is a gravelly soil weathered from cherty limestone on sharply dissected uplands, at a median slope of 35 percent there. It drains fast and dries out, so plantings on it need to tolerate drought, and level space has to be built with terraces, low walls and steps.
Clearing comes first and is regulated. Metro Water Services’ grading permit page states that tree cutting requires a tree removal permit, so opening up a wooded slope for a view, a patio or sun on a lawn starts with that check. From there, Hardscape Construction builds the walls and steps, and Landscape Design & Installation plants the banks between them.
What changes for a Bellevue yard that sits near a drainageway?
The soil is good, but the water has right of way. Arrington, 16 percent of the ground mapped around Bellevue, is very deep and well drained with a thick dark surface layer, formed in silty alluvium on flood plains and along drainageways. Armour, the most common soil there at 32 percent, is also very deep and well drained, on terraces and foot slopes. Both plant well.
What they share is position. They sit where water from the hillsides above arrives, so a bed, a fence line or a patio placed across that path turns into a dam. Before anything is built, the route water takes across the lot is traced and kept open, then shaped with grading or carried in a drain where it has to pass a hard surface.
Is my Bellevue yard ready for a new patio or outdoor kitchen?
Probably, once the old surface and the grade are checked. With a median build year of 1991 in the 37221 ZIP area and 24 percent of homes built before 1980, many Bellevue patios and decks have been in place for thirty years or more, and the ground around them has had time to settle toward the house. Mimosa, a slowly permeable clay on 13 percent of the ground, is the soil most likely to hold water under an old slab.
A new outdoor living space starts by breaking out what has failed and building a compacted base pitched away from the foundation. Landscaping on an existing lot with a grade change of 18 inches or less is exempt from Metro’s grading permit, which covers most patio prep.
04Answers
Bellevue questions
Do I need a permit to cut down a tree in Bellevue, TN?
Yes. Bellevue is part of Metro Nashville, and Metro Water Services’ grading permit page states that tree cutting requires a tree removal permit. Check before clearing for a patio, a wall or a view, and fold the answer into the project plan rather than finding out halfway through.
How do you keep soil from washing off a Bellevue hillside?
By slowing the water and holding the slope. Terraces with low retaining walls, planted banks and mulch on bare soil all cut erosion on gravelly Bodine ground, which sits at a median slope of 35 percent around Bellevue. Where water concentrates, a dry creek bed or a drain carries it down without cutting a gully.
Is the soil in low parts of Bellevue good for planting?
Usually, yes. Arrington, found on flood plains and along drainageways around Bellevue, is very deep and well drained with a thick dark surface layer, and Armour on the terraces is very deep and well drained too. The care point is placement: beds and patios should not block the path water takes.
Why is my Bellevue yard dry on the slope and wet at the bottom?
Because water runs through the gravelly hillside soil and gathers where the ground levels out. Bodine is somewhat excessively drained, so it dries fast, and the runoff ends up on the flatter terraces and drainageways below. A drain or regrading at the toe of the slope usually settles it.