Service area · Cheatham County
Ashland City: hill lots and bottom lots need different plans
Half the ground sampled around Ashland City is steep Hawthorne upland; another fifth is flat Ennis and Beason soil along drainageways and low terraces.
TL;DR
Ashland City is in Cheatham County, about 23 miles from Brentwood, with 5,424 residents and a median home built in 2002; 32 percent of homes date from 2010 or later. The ground splits two ways. Hawthorne and Sulphura uplands, with median slopes of 40 percent, need walls, terraces and erosion control. Ennis and Beason soils on flood plains and low terraces are flat, and Beason is somewhat poorly drained, so those lots need drainage worked out before anything is built.
What landscaping works on an Ashland City hill lot?
Terraces and plantings that hold the slope rather than lawn that fights it. Hawthorne covers about 50 percent of the ground sampled near the town center, a moderately deep, somewhat excessively drained soil formed from siltstone and cherty limestone, at a median slope of 40 percent. Grass struggles on it, mowing it is unsafe, and it dries fast in summer.
With nearly a third of Ashland City’s homes built in 2010 or later, many hill lots also carry the cut and fill banks left when the house pad was made: bare subsoil that will wash until something grows on it. Those banks are the first priority, held by low walls or planting, then the slope is laid out in beds of shrubs and groundcover. Hardscape Construction builds the terraces and Landscape Design & Installation plants them.
Why does my low-lying Ashland City yard stay soggy?
If it sits on Beason soil, the soil itself is the reason. Beason, about 4 percent of the ground sampled, is very deep and somewhat poorly drained, formed in fine-textured alluvium on low stream terraces with slopes of 0 to 3 percent. Soils with that rating hold water near the surface for long stretches in winter and spring.
Ennis, a bigger share at 18 percent, behaves differently: it is gravelly and drains readily, but it lies on flood plains and narrow strips beside drainageways, where water arrives from upstream. On either, a drain is only as good as its outlet, and on flat ground the outlet is the hard part. Shaping the yard to move surface water, raising beds and steering roof water away from the house usually come first. That work belongs to Drainage Solutions, with Grading & Site Prep doing the shaping.
What should come first outside a newer Ashland City home?
Water, then the banks, then the parts you sit on. A house built in the last fifteen years often still has downspouts dumping at the corners and a builder grade that has settled near the foundation. On a hill lot that water cuts the banks below; on a low lot it collects where the patio was meant to go.
Once the water is handled, the order follows the site: hold the slopes, then build the patio, fire pit or walk on ground that will stay put, then plant around them. Doing it in phases is fine as long as each phase fits the whole plan. Project Planning & Consulting lays out that sequence, including any permitting questions, and Outdoor Living & Patios builds the spaces at the end of it.
04Answers
Ashland City questions
What soil is my Ashland City lot on?
Most likely Hawthorne if it is on a hillside, and Ennis or Beason if it sits on flat ground near a drainageway. Hawthorne covers about half the ground sampled near the town center. The difference matters: the hillside soil drains fast and erodes, while Beason on the low terraces holds water. A site visit confirms which you have.
How do I keep a new cut bank from washing out in Ashland City?
Cover it and keep water from pouring over its top. A bank cut during construction is bare subsoil, and on Hawthorne ground near 40 percent slope it gullies quickly. Erosion-control fabric, dense planting and mulch hold the face, while a swale or drain above it carries roof and driveway runoff around the edge.
Can a patio be built on low ground in Ashland City?
Yes, if the base is raised and the water has somewhere to go. On somewhat poorly drained Beason soil, a patio is set slightly above the surrounding grade on a deeper compacted gravel base, pitched away from the house, with the lawn around it shaped so runoff passes by rather than pooling at an edge.
How long does a landscaping project take in Ashland City?
Patios and other hardscapes usually take one to three weeks once the crew starts, with site prep a few days to a week before that. Ashland City is about 23 miles from the Brentwood base, so the estimate after the free consultation also sets out how the work days will run.